Cambium Networks PTP 820 Series User Manual page 837

Chapter 18: Ethernet Services and Interfaces (CLI)
root> ethernet service add type p2p sid 10 admin operational evc-id test
description east_west
root>
root> ethernet service sid 10
service[10]>
service[10]>sp add sp-type pipe int-type s-tag spid 1 interface eth slot
1 port 1 sp-name test1
service[10]>
service[10]>sp add sp-type pipe int-type s-tag spid 2 group mc-abc1 sp-
name test2
service[10]>
Configuring Service Point Ingress Attributes (CLI)
A service point's ingress attributes are attributes that operate upon frames ingressing via the service point. This
includes how the service point handles the CoS of ingress frames and how the service point forwards frames to
their next destination within the service.
This section includes:
•
Enabling and Disabling Broadcast Frames (CLI)
•
CoS Preservation and Modification on a Service Point (CLI)
•
Enabling and Disabling Flooding (CLI)
Enabling and Disabling Broadcast Frames (CLI)
To determine whether frames with a broadcast destination MAC address are allowed to ingress the service via this
service point, go to service view for the service and enter the following command:
service[SID]>sp broadcast set spid <sp-id> state <state>
Table 187 Enable/Disable Broadcast Frames CLI Parameters
Parameter Input Type
sp-id Number
state Variable
The following command allows frames with a broadcast destination MAC address to ingress Service 37 via Service
Point 1.
service[37]>sp broadcast set spid 1 state allow
The following command prevents frames with a broadcast destination MAC address from ingressing Service 37 via
Service Point 1.
Permitted Values Description
1-32 for P2P and The Service Point ID.
MP services.
1-30 for MNG
services.
Allow Determines whether frames with a broadcast
destination MAC address are allowed to ingress
disable
the service via this service point.
phn-3965_006v002
Page 18-18
Configuring Ethernet Services (CLI)