Chapter 19: Quality of Service (QoS) (CLI)
Displaying Rate Meter Statistics for an Interface (CLI)
For the rate meter (policer) at the logical interface level, you can display the following statistics counters:
•
Green Frames
•
Green Bytes
•
Yellow Frames
•
Yellow Bytes
•
Red Frames
•
Red Bytes
Note
Rate meter (policer) counters are displayed in granularity of 64 bits.
The following commands display rate meter counters for the available frame types and Ethertypes:
eth type eth [x/x]>rate-meter unicast show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter multicast show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter broadcast show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter ethertype1 show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter ethertype2 show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
eth type eth [x/x]>rate-meter ethertype3 show statistics clear-on-read
<clear-on-read> layer-1 <layer-1>
Table 233 Displaying Rate Meter Statistics CLI Parameters
Parameter
Input Type
clear-on-read
Boolean
layer 1
Boolean
The following commands display rate meter counters for GbE 1, for each of the available frame types and
Ethertypes. These commands clear the counters after displaying them.
eth type eth [1/1]>rate-meter unicast show statistics clear-on-read yes
layer-1 no
Permitted Values
Description
yes
If you enter yes, the statistics are cleared
once you display them.
no
yes
yes
statistics, including preamble and IFG.
no
no
statistics.
phn-3965_006v002
Page 19-22
Configuring Policers (Rate Metering) (CLI)
– Statistics are represented as Layer 1
– Statistics are represented as Layer 2