Cambium Networks PTP 820 Series User Manual page 965

Chapter 21: TDM Services and Interfaces (CLI)
Configuring TDM Cards and Interfaces (CLI)
This section includes:
•
Configuring the E1/DS1 Interface (CLI)
•
Configuring the E1/DS1 Parameters (CLI)
Configuring the E1/DS1 Interface (CLI)
To enable the slot, enter the following command in root view:
root> platform shelf-manager admin set slot <slot> state enable
To enable the E1/DS1 interface, enter the following command in root view:
root> platform if-manager set interface-type tdm slot <slot> port <port>
admin <admin>
Note
To enable or disable an E1/DS1 interface, use the
Configuring the E1/DS1 Parameters
Table 278 TDM Slot Configuration CLI Parameters
Parameter Input Type
slot Number
type Variable
port Number
admin Variable
To verify the parameters of the slot you just configured, enter the following command:
root> pwe3 pwc config show slot 3
Configuring the E1/DS1 Parameters (CLI)
You can use the following commands to configure the E1/DS1 parameters. You must enter these commands from
pwe3 view:
(CLI).
Permitted Values Description
For TDM cards in an
expansion slot: 2-3
For the fixed E1/DS1
interface: 1
LIC-T16-ACR
LIC-T16-ACR
LIC-T155-ACR
LIC-T155-ACR
•
STM-1: 1-63 The physical port number of the port.
•
OC-3: 1-84
up Enter
down disable the port.
phn-3965_006v002
Page 21-4
Configuring TDM Cards and Interfaces (CLI)
pwe3 tdm enable slot command. See
– A 16xE1/DS1 TDM card.
– A 1 x ch-STM-1/OC-3 card.
to enable the port or
up
to
down