Cambium Networks PTP 820 Series User Manual page 551

Chapter 9: TDM Services and Interfaces
Figure 321 Pseudowire Services Edit Page – Multiple Selection Operation
Deleting TDM Pseudowire Services
To delete a service, select the service in the TDM PseudoWire Services table and click Delete. The Admin status of
the service must be Down in order to delete the service.
To delete multiple services:
1 Select the services in the TDM PseudoWire Services table or select all the services by selecting the check
box in the top row.
2 Click Delete underneath the TDM PseudoWire Services table.
Limitations on Available Endpoints
A slot, group, or interface will not appear in the Slot/Group/Port field if any of the following conditions exist:
•
An SAP service point has been configured on the interface.
•
For the E1/DS1 interface, the E1/DS1s have all already been assigned to other services.
•
For a radio interface or group, all VCs have already been assigned to other services.
•
For a TDM interface, there is no available TDM service ID.
•
For TDM interface, there are no available TDM resources.
•
After opening the TDM Services Creation page, but before selecting a slot or group, the last available Service
ID was configured by another user, or the maximum amount of services (256) was reached for the unit.
The following additional condition applies if you are in the Interface #2 screen:
•
For E1/DS1, an E1/DS1 has already been selected as the first interface.
phn-3965_006v002
Page 9-43
Configuring TDM Pseudowire Services