Cambium Networks PTP 820 Series User Manual page 574

Chapter 9: TDM Services and Interfaces
Table 109 Pseudowire TDM Service Parameters
Parameter
Service ID
Admin State
Service Type
Tunnel Type
TDM Interface
TDM Port/ Bundle ID
PW Profile ID
Tunnel ID or Tunnel Group ID
Clock Recovery Master
Source Tunnel Identifier
Destination Tunnel Identifier
Definition
A unique ID that identifies the service. Once you have added the service,
you cannot change the Service ID. Options are 1-16.
Select one of the following options:
•
Enable – The service is functional.
•
Disable – The service is disabled until this parameter is changed to
Enabled. In this mode, the service occupies system resources but is
unable to receive and transmit data.
Select the pseudotype protocol you want to use for the service:
•
E1 SAToP – Service uses SAToP protocol
•
CESoPSN – Service uses CESoP protocol without CAS signaling
•
CAS-CESoPSN – Service uses CESoP protocol with CAS signaling.
Only SAToP is supported in this release.
Select the encapsulation type to use with the service. Options are:
•
UDP/IP – UDP/IP
•
Eth – MEF-8
Only Eth is supported in this release.
Select the TDM port to use with the service.
Reserved for future use.
Select the TDM profile to use with the service. The TDM profile
determines the behavior of the TDM service, including the buffer, payload
suppression, and other parameters. A profile can be used by multiple
TDM services.
You can define up to 64 TDM profiles for the unit in the PseudoWire
Profiles page. See Configuring Pseudowire
Select the TDM tunnel or tunnel group to use with the service. The tunnel
determines how traffic over the service passes through the network. In
this version, encapsulation must use the MEF-8 protocol.
Up to 16 tunnels can be configured. TDM tunnels are configured in the
PseudoWire Tunnels page. Tunnel groups are configured in the Tunnel
Groups page. See Configuring Pseudowire Tunnels and Tunnel
Select Enable to use this service as a reference for clock recovery.
Otherwise, select Disable.
Enter the source ECID for the Ethernet tunnel.
Note: The ECID must be unique for each service.
Enter the destination ECID for the Ethernet tunnel.
phn-3965_006v002
Page 9-66
Configuring Advanced Pseudowire Parameters
Profiles.
Groups.