Cambium Networks PTP 820 Series User Manual page 828

Chapter 18: Ethernet Services and Interfaces (CLI)
Table 181 Ethernet Service EVC Description CLI Parameters
Parameter Input Type
evc
Text String
description
To display a service's EVC description, go to service view for the service and enter the following command:
service[SID]>service description show
For example, the following commands add the EVC ID "East_West" and the EVC description "Line-to-Radio" to
Service 10:
service[10]>service evcid set East_West
service[10]>service description set Line-to-Radio
Deleting a Service (CLI)
Before deleting a service, you must first delete any service points attached to the service (refer to
Service Point (CLI)).
Use the following command to delete a service:
root>ethernet service delete sid <sid>
The following command deletes Service 10:
root>ethernet service delete sid 10
Permitted Values Description
Up to 64 A text description of the service. This parameter
characters. does not affect the network element's behavior,
but is used by the NMS for topology management.
phn-3965_006v002
Page 18-9
Configuring Ethernet Services (CLI)
Deleting a