Cambium Networks PTP 820 Series User Manual page 92

Chapter 1: Introduction
Interfaces
Reference Guide to Web EMS Menu Structure
Configuring RFU3/SFP5,RFU3/2.5GE5 as
or RFU Interface(PTP 820F only)
On PTP 820F, the combo port labelled RFU3/SFP5
(SFP) and RFU3/2.5GE5 (RJ-45) can be configured as
either an RFU interface (RFU3) or an Ethernet
interface (Eth3). By default, this port is an RFU
interface.
Figure: RFU3/SFP5 and
RFU3/2.5GE5 Combo Port
To change the port's use from RFU to Ethernet or
Ethernet to RFU:
1 Set the port's admin state to Down in the
Interface Manager.
•
If the port is currently configured as an RFU
port, it is listed as Radio: Slot 1, Port 5 in
the Interface Manager.
•
If the port is currently configured as an
Ethernet port, it is listed as Ethernet: Slot 1,
Port 5 in the Interface Manager.
See Enabling the Interfaces (Interface
Manager).
2 In the Radio Unit page, set the Admin status
of Radio Unit: Slot 1, Port 3 to Down.
3 If there are any service points attached to
the port, remove them.
4 If the port is configured as a Sync source,
delete the port as a Sync source.
5 If the port belongs to any interface groups,
such as LAG, remove the port from the group.
6 Select Platform > Interfaces >
RFU/Ethernet. The RFU/Ethernet Interface
Configuration page opens.
phn-3965_006v002
Page 1-46
an Ethernet