Chapter 12: Alarm Management and Troubleshooting
Performing TDM Diagnostics
This section includes:
•
Performing Loopback on E1/DS1s
Performing Loopback on E1/DS1s
To perform PDH loopback on a TDM line:
1
Select TDM > Diagnostics > PDH Loopback. The PDH Loopback page opens.
Figure 409 PDH Loopback Page
2
In the Select a slot field at the top of the PDH Loopback page, select the slot with the TDM card on which
you want to run the loopback.
3
In the TDM Loopback Timeout field, specify the number of minutes before timing out a loopback operation.
4
Click Apply to save the settings.
5
For each interface, select the interface and click Edit. The PDH Loopback – Edit page opens.
phn-3965_006v002
Page 12-22
Performing Diagnostics