Cambium Networks PTP 820 Series User Manual page 943

Chapter 20: Ethernet Protocols (CLI)
Setting and Viewing the Bridge Level MSTI Parameters (CLI)
To set the bridge priority for an MSTI, enter the following command in root view:
root> ethernet mstp set instance <msti-id> msti-bridge-priority <msti-
bridge-priority>
To display the bridge parameters of an MSTI, enter the following command in root view:
root> ethernet mstp show-msti-attributes instance <msti-id>
Table 271 Bridge Level MSTI CLI Parameters
Parameter Input Type
instance Number
msti-bridge- Number
priority
interface Variable
slot Number
port Number
group Variable
The following command sets the bridge priority for MSTI 15 to 28672:
root> ethernet mstp set instance 15 msti-bridge-priority 28672
Permitted Values Description
1-16 Enter the MSTI ID of the MSTI you want to
configure.
0-61440, in steps of The MSTI writeable portion of the Bridge ID.
4096.
eth Enter the type of interface:
radio
– Ethernet
eth
pwe
radio
– TDM
pwe
1
ethernet: 1-6 The interface you want to configure.
radio: 1-2
management: 1-2
tdm: 1
rp1 To display bridge parameters for a 1+1 HSB
rp2 group, a LAG group, or a Multi-Carrier ABC
rp3 group, use this parameter instead of the
rp4 interface, slot, and port parameters to
lag1 identify the group. See:
lag2 •
Configuring HSB Radio Protection (CLI)
lag3
•
Configuring Link Aggregation (LAG) and
lag4
LACP
mc-abc1
•
Configuring Multi-Carrier ABC (CLI)
mc-abc2
mc-abc3
mc-abc4
phn-3965_006v002
Page 20-20
– Radio
(CLI)
Configuring MSTP (CLI)