Cambium Networks PTP 820 Series User Manual page 922

Chapter 19: Quality of Service (QoS) (CLI)
For example:
The integrity column indicates whether the PM is valid:
•
0 indicates a valid entry.
1 indicates an invalid entry. This can occur for a number of reasons, including but not limited to a disconnected
cable, a missing SFP module, muting of a radio interface, and an operational status of Down
Displaying Service Bundle-Level PMs (CLI)
PTP 820G and PTP 820F supports the following counters per service bundle at the service bundle level:
•
Transmitted Green Packets (64 bits counter)
•
Transmitted Green Bytes (64 bits counter)
•
Transmitted Green Bits per Second (32 bits counter)
•
Dropped Green Packets (64 bits counter)
•
Dropped Green Bytes (64 bits counter)
•
Transmitted Yellow Packets (64 bits counter)
•
Transmitted Yellow Bytes (64 bits counter)
•
Transmitted Yellow Bits per Second (32 bits counter)
•
Dropped Yellow Packets (64 bits counter)
•
Dropped Yellow Bytes (64 bits counter)
To display service bundle-level PMs, enter interface view for the interface and enter the following command:
eth type eth [x/x]> tm-service-bundle show statistics service-bundle-id
<service-bundle-id> clear-on-read <clear-on-read> layer-1 <layer-1>
To clear service bundle-level PMs for all service bundles on an interface, enter interface view for the interface and
enter the following command:
eth type eth [x/x]> tm-service-bundle clear statistics
Table 255 Egress Service Bundle Level PMs CLI Parameters
phn-3965_006v002
Page 19-55
Displaying Egress Statistics (CLI)