Chapter 19: Quality of Service (QoS) (CLI)
eth type eth [1/1]> service-bundle-shaper edit service-bundle-id 1 admin-
state enable profile-id 4
Configuring Egress Line Compensation for Shaping (CLI)
You can configure a line compensation value for all the shapers under a specific logical interface. This value is used
to compensate for Layer 1 non-effective traffic bytes on egress.
To set the egress line compensation value, go to interface view for the interface and enter the following command:
eth type eth [x/x]>shaping-compensation-value set <value>
To display the egress line compensation value, go to interface view for the interface and enter the following
command:
eth type eth [x/x]>shaping-compensation-value get
Table 245 Egress Line Compensation for Shaping CLI Parameters
Parameter
Input Type
value
Number
The following command sets the egress line compensation value to 0 on Ethernet port 1:
eth type eth [1/1]>shaping-compensation-value set 0
Permitted Values
Description
0 – 26 (even numbers
Shapers attached to the interface use this
only)
value to compensate for Layer 1 non-
effective traffic bytes on egress.
phn-3965_006v002
Page 19-39
Configuring Shapers (CLI)