Cambium Networks PTP 820 Series User Manual page 190

Chapter 3: Configuration Guide
Note
For a full explanation of Ethernet Services, service types, and attached interface types, see
Configuring Ethernet
5 Click Next. Page 2 of the 1+1 HSB Quick Configuration wizard opens.
Figure 65 1+1 HSB Quick Configuration Wizard (PTP 820G) – Page 2
6 In the Radio #2 Interface field, select the Standby radio interface for the link. Alternatively, click the interface
in the graphical representation of the unit. The selected interface is surrounded by an orange circle, as shown
in Figure 65. This interface will be the Standby radio in the protection group.
7 In the Revertive Mode field, select Yes or No to determine whether or not the HSB radio protection group
will operate in revertive mode. When revertive mode is enabled, following a switchover the system initiates a
revertive protection switchover back to the original receiver ten minutes after proper link and/or equipment
conditions are restored. This ensures that the primary path is used whenever possible.
8 Click Next. Page 3 of the 1+1 HSB Quick Configuration wizard opens.
Figure 66 1+1 HSB Quick Configuration Wizard (PTP 820G) – Page 3
9 In the TX Frequency (MHz) field, set the transmission radio frequency in MHz.
10 In the RX Frequency (MHz) field, set the received radio frequency in MHz.
Service(s).
phn-3965_006v002
Page 3-32
Configuring a Link Using the Quick Configuration Wizard