Cambium Networks PTP 820 Series User Manual page 709

Chapter 14: Getting Started (CLI)
root> platform management protection set manual-switch
To perform a force switch, enter the following command in root view:
root> platform management protection set force-switch
Performing Lockout (CLI)
At any point, you can perform lockout, which prevents switchover to the standby unit in all cases other than a
force switch.
To perform lockout, enter the following command in root view:
root> platform management protection lockout set admin on
To release lockout, enter the following command in root view:
root> platform management protection lockout set admin off
Disabling Unit Redundancy (CLI)
You can disable unit redundancy at any time.
To disable protection, enter the following command in root view.
root> platform management protection set admin disable
If in-band management is being used, unit redundancy must be disabled in the following order to ensure that
management is not lost:
1. Disable unit redundancy in the active unit of the remote pair. The link remains up and no switchover
takes place.
2. Change the IP address of the active remote unit.
3. Disable all active traffic interfaces on the active remote unit. Line interfaces should be disabled first,
followed by radio interfaces, since disabling a radio interface causes switchover. See
Interfaces (Interface Manager)
4. Disable unit redundancy in the active unit of the local pair. The link remains up and no switchover
takes place.
5. Change the IP address of the active local unit.
6. Disable all active traffic interfaces on the active local unit. Line interfaces should be disabled first,
followed by radio interfaces, since disabling a radio interface causes switchover. See
Interfaces (Interface Manager)
7. Disable unit redundancy on the both the remote and the local units that were the standby units and
have now become the active units.
Configuring Unit Redundancy for the PTP 820 Split Mount (CLI)
(CLI). This causes switchover on the remote pair.
(CLI). This causes switchover on the local pair.
phn-3965_006v002
Page 14-14
Enabling the
Enabling the