Cambium Networks PTP 820 Series User Manual page 396

Chapter 6: Ethernet Services and Interfaces
Figure 200 Physical Interfaces - Edit Page
3. Optionally, in the Description field, enter a description of the interface.
4. In the Media type field, select the physical interface layer 1 media type. Options are:
o
Auto-Type – NA.
o
RJ45 – An electrical (RJ-45) Ethernet interface.
o
SFP – An optical (SFP) Ethernet interface.
o
Radio – A radio interface.
5. In the Auto negotiation field, select On to enable or Off to disable Auto-Negotiation. When the Media-Type
is Radio, Auto Negotiation is always Off.
6. In the Speed field, select the maximum speed of the interface, in Mbps. Options are:
o
Ethernet RJ-45 interfaces – 100 and 1000.
o
Ethernet SFP interfaces – Only 1000 is supported.
o
Radio interfaces – The parameter is read-only and set by the system to 1000.
7. In the Duplex field, select the interface's duplex setting (Full-Duplex or Half-Duplex). Only Full-Duplex is
available in this release.
8. Click Apply, then Close.
Table 67 describes the status parameters that appear in the Physical Interfaces page.
Table 67 Physical Interface Status Parameters
phn-3965_006v002
Page 6-25
Configuring Ethernet Interfaces