Cambium Networks PTP 820 Series User Manual page 704

Chapter 14: Getting Started (CLI)
Configuring Unit Redundancy for the PTP 820 Split
Mount (CLI)
This section explains how to configure unit redundancy and includes the following topics:
•
Configuring Unit Redundancy (CLI)
•
Configuring Ethernet Interface Protection (CLI)
•
Enabling Unit Redundancy (CLI)
•
Changing the Configuration after Enabling Unit Redundancy (CLI)
•
Running Commands in the Standby Unit (CLI)
•
Viewing Link and Protection Status and Activity (CLI)
•
Switchover (CLI)
•
Performing Lockout (CLI)
•
Disabling Unit Redundancy (CLI)
For an overview of unit redundancy and a description of the relevant cabling requirements, see:
•
Unit Redundancy Overview
•
Cabling Requirements for Unit Redundancy
To configure unit redundancy, you must perform the following steps:
1. Verify that the proper cables for unit redundancy are connected to the units. See
for Unit Redundancy.
2. Configure Ethernet interface protection. See
3. Enable unit redundancy. See
Configuring Unit Redundancy (CLI)
•
Before configuring unit redundancy, verify that both units have the same hardware part number see,
Displaying Unit Inventory
If the units do not have the same software version, upgrade each unit to the most recent software release (see
Upgrading the Software
To configure unit redundancy, you must perform the following steps:
1. Verify that the PC or laptop being used to configure the devices is directly connected to the management port
of the unit that will be the active unit.
2. Configure the unit that will be the active unit so that it will have a working radio link by performing all
necessary radio configurations, such as configuring the MRMC scripts, setting the frequency, unmuting the
radio, and setting up radio groups such as XPIC or Multi-Carrier ABC (Multi-Radio).
3. Perform all necessary Ethernet and TDM configurations on the unit that will be the active unit , such as
defining Ethernet and TDM services.
Configuring Ethernet Interface Protection
Enabling Unit Redundancy (CLI).
(CLI). and the same software version (see
(CLI)).
phn-3965_006v002
Page 14-9
Configuring Unit Redundancy for the PTP 820 Split Mount (CLI)
Displaying Current Software Versions
Cabling Requirements
(CLI).
(CLI).