Chapter 20: Ethernet Protocols (CLI)
Displaying the LLDP Remote System Parameters (CLI)
This section includes:
•
Displaying the LLDP Remote Unit Parameters (CLI)
•
Displaying the LLDP Remote Management Data per Port (CLI)
Note
Remote information is not displayed for ports that belong to a LAG group.
Displaying the LLDP Remote Unit Parameters (CLI)
To display the peer's LLDP unit parameter information, starting from a specific time, enter the following command
in root view. If no time is specified, all data is displayed.
root> ethernet lldp agent-remote-table-show agent-start-time <agent-
start-time> interface eth slot <slot> port <port>
The following information is displayed:
•
Time Mark
– The time the entry was created.
•
Interface Type/Slot/Port
•
Rem Dest Mac Address
•
– An arbitrary local integer value used by this agent to identify a particular connection
Remote Index
instance, unique only for the indicated peer.
•
Remote Chassis ID subType
•
Remote Chassis ID
•
Rem Port ID subType
•
Rem Port ID
– An octet string used to identify the port component associated with the peer.
•
Rem Port Description
•
Rem System Name
– The peer's system name.
•
Rem System Description
Note
The Rem Port Description, Rem System Name, and Rem System Description fields are not used in the
current version.
•
Rem System Cap Supported
on the peer. The bitmap is defined by the following parameters:
o
0 - other
o
1 - repeater
o
2 - bridge
o
3 - wlanAccessPoint
– The port for which you are displaying data about the peer.
– The peer LLDP agent's destination MAC Address.
– The type of encoding used to identify the peer's chassis.
– An octet string used to identify the peer's chassis.
- The type of port identifier encoding used in the peer's Port ID.
– A description of the peer's port.
– The peer's system description.
– The bitmap value used to identify which system capabilities are supported
phn-3965_006v002
Page 20-34
Configuring LLDP (CLI)