Cambium Networks PTP 820 Series User Manual page 902

Chapter 19: Quality of Service (QoS) (CLI)
eth type eth [x/x]> queue-shaper add capability service-bundle-id
<service-bundle-id> cos <cos> admin-state <admin-state> profile-id
<profile-id>
To change the queue shaper profile attached to a queue, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> queue-shaper edit service-bundle-id <service-bundle-
id> cos <cos> admin-state <admin-state> profile-id <profile-id>
To display the queue shaper profile attached to a queue, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> queue-shaper show configuration service-bundle-id
<service-bundle-id> cos <cos>
To remove a queue shaper profile from a queue, go to interface view for the interface and enter the following
command:
eth type eth [x/x]> queue-shaper delete service-bundle-id <service-
bundle-id> cos <cos>
Table 242 Attaching Shaper Profile to Queue CLI Parameters
Parameter Input Type
service- Number
bundle-id
cos Number
admin-state Variable
profile-id Number
The following command adds Queue Shaper Profile 5 to queues with CoS 0, on Service Bundle 1, on Ethernet port
1, and enables shaping on these queues:
eth type eth [1/1]> queue-shaper add capability service-bundle-id 1 cos 0
admin-state enable profile-id 5
The following command changes the Queue Shaper Profile assigned in the previous command to Queue Shaper
Profile 2:
Permitted Values Description
1 – 63 The service bundle to which you are
attaching the queue shaper profile.
Note: In the
current release, only
Service Bundle 1 is
supported.
0 – 7 The CoS queue ID of the queue to which
you want to assign the shaper. Queues are
numbered according to CoS value.
enable Select
shaping on the queue, or
disable
disable egress queue shaping on the
queue. If you set shaping to
shaper profile remains attached to the
queue, but does not affect traffic.
1 – 32 Enter the ID of one of the configured
queue shaper profiles.
phn-3965_006v002
Page 19-35
Configuring Shapers (CLI)
to enable egress queue
enable
disable
disable
to
, the