Cambium Networks PTP 820 Series User Manual page 935

Chapter 20: Ethernet Protocols (CLI)
root> ethernet g8032 show-erpi-sp-state erpi-id 1 SP east
The following is an example of this command's output.
Table 264 G.8032 Service Point Display Command Output Parameters
Parameter
ERPI ID
SP Index
SP ID
Active State
R-APS Channel
Forwarding State
Data Forwarding State
RPL Link Blocked State
Defect State
TX R-APS Frames
TX R-APS SF
TX R-APS NR
TX R-APS RB
TX R-APS SD
TX R-APS FS
TX R-APS MS
TX R-APS Event
Description
A unique ID that identifies the ERPI.
Identifies the service point in the ERPI.
The Service Point ID.
Indicates whether or not the service point is active for traffic forwarding.
Indicates whether the service point is forwarding R-APS messages.
Indicates whether the service point is in unblocked (forwarding) state.
Only relevant if the ERPI to which the service point belongs is the RPL
owner. Indicates whether the service point is in blocked state.
Indicates whether the service point is in Signal Fail (SF) or Signal Defect
(SD) state.
Note: Support for Signal Defect state is planned for future release.
The number of R-APS frames that have been transmitted via the service
point.
The number of R-APS Signal Fail (SF) frames that have been transmitted
via the service point.
The number of R-APS No Request (NR) frames that have been transmitted
via the service point.
The number of R-APS RPL Blocked (RB) frames that have been
transmitted via the service point.
The number of R-APS Signal Degrade (SD) frames that have been
transmitted via the service point.
The number of R-APS Forced Switch (FS) frames that have been
transmitted via the service point.
The number of R-APS Manual Switch (MS) frames that have been
transmitted via the service point.
Reserved for future use.
phn-3965_006v002
Page 20-12
Configuring G.8032 (CLI)