Cambium Networks PTP 820 Series User Manual page 326

Chapter 5: Radio Configuration
Parameter
Remote Most Severe
Alarm
Remote Tx Output Level
Remote Radio Mute
Remote IP Address
Remote IPv6 Address
Displaying Communication Status with Remote Radio (CLI)
To display the communication status with the remote radio, enter the following command in radio view:
radio[x/x]>remote-unit communication status show
Displaying Remote Radio's Link ID and Location (CLI)
To display the remote radio's Link ID, enter the following command in radio view:
radio[x/x]>remote-unit show link-id
To display the remote radio's slot ID (location in the chassis), enter the following command in radio view:
radio[x/x]>remote-unit show slot-id
Muting and Unmuting the Remote Radio (CLI)
To mute or unmute the remote radio, enter the following command in radio view:
radio[x/x]>remote-unit mute set admin <admin>
To display the mute status of the remote radio, enter the following command in radio view:
radio[x/x]>remote-unit mute show status
Table 46: Remote Radio Mute and Unmute CLI Parameters
Parameter
admin
The following command mutes the remote radio connected to fixed radio interface 2:
radio[1/2]>remote-unit mute set admin on
The following command unmutes the remote radio connected to fixed radio interface 1:
Definition
Read-only. The level of the most severe alarm currently active on the
remote unit.
The remote unit's Tx output level, if the remote unit has been configured
to operate at a fixed Tx level (in dBm).
To mute the TX output of the remote radio, select On. To unmute the TX
output of the remote radio, select Off.
The IPv4 IP address of the remote unit.
The IPv6 IP address of the remote unit.
Input Permitted
Type Values
Variable on
off
phn-3965_006v002
Page 5-12
Configuring the Remote Radio Parameters
Description
Mutes (on) or unmutes (off) the remote unit.