Cambium Networks PTP 820 Series User Manual page 687

Chapter 12: Alarm Management and Troubleshooting
Displaying Remote MEPs
To display a list of remote MEPs (RMEPs) and their parameters:
1. Select Ethernet > Protocols > SOAM > MEP. The SOAM MEP page opens
2. Select a MEP and click RMEP List. The SOAM MEP DB table is displayed.
Figure 422 SOAM MEP DB Table
Table 126 lists and describes the parameters displayed in the SOAM MEP DB table. To return to the SOAM MEP
page, click Back to MEP.
Table 126 SOAM MEP DB Table Parameters
Parameter
RMEP ID
RMEP Operational State
RMEP Last rx CCM MAC
Address
RMEP Last CCM OK or Fail
Timestamp
RMEP Last rx CCM RDI
Indication
RMEP Last rx CCM Port
Status TLV
RMEP Last rx CCM
Interface Status TLV
Definition
The remote MEP ID.
The operational state of the remote MEP.
The MAC Address of the interface on which the remote MEP is located.
The timestamp marked by the remote MEP indicated the most recent
CCM OK or failure it recorded. If none, this field indicates the amount of
time since SOAM was activated.
Displays the state of the RDI (Remote Defect Indicator)bit in the most
recent CCM received by the remote MEP:
•
True – RDI was received in the last CCM.
•
False – No RDI was received in the last CCM.
The Port Status TLV in the most recent CCM received from the remote
MEP. Reserved for future use.
Displays the operational status of the interface on which the remote MEP
has been defined.
phn-3965_006v002
Page 12-37
Performing Diagnostics
(Figure 417).