Cambium Networks PTP 820 Series User Manual page 220

Chapter 3: Configuration Guide
9. For each radio carrier or XPIC group, configure the following radio parameters:
i In the TX Frequency (MHz) field, set the transmission radio frequency in MHz.
ii In the RX Frequency (MHz) field, set the received radio frequency in MHz.
iii In the TX Level (dBm) field, enter the desired TX signal level (TSL). The range of values depends on the
frequency and RFU type.
iv To mute the TX output of the radio carrier, select On in the TX mute field. To unmute the TX output of
the radio carrier, select Off.
10. Click Next. The Radio MRMC Script Configuration page opens. You can configure the MRMC script
parameters for each interface. For an XPIC group, you configure the parameters for the group rather than
the individual interfaces.
Figure 86 N + 0 Multi Carrier ABC Quick Configuration Wizard – Radio MRMC Script Configuration Page – PTP 820G
Figure 87 N + 0 Multi Carrier ABC Quick Configuration Wizard – Radio MRMC Script Configuration Page – PTP 820F
Configuring a Link Using the Quick Configuration Wizard
phn-3965_006v002
Page 3-62