Chapter 17: Radio Configuration (CLI)
Configuring and Viewing Radio PMs and Statistics
(CLI)
This section includes:
•
Displaying General Modem Status and Defective Block PMs(CLI)
•
Displaying Excessive BER (Aggregate) PMs (CLI)
•
Displaying BER Level and Configuring the Excessive BER Thresholds (CLI)
•
Configuring RSL Thresholds (CLI)
•
Configuring TSL Thresholds (CLI)
•
Displaying RSL and TSL Levels (CLI)
•
Configuring the Signal Level Threshold (CLI)
•
Configuring the MSE Thresholds and Displaying the MSE PMs (CLI)
•
Configuring the XPI Thresholds and Displaying the XPI PMs (CLI)
•
Displaying ACM PMs (CLI)
Displaying General Modem Status and Defective Block
PMs(CLI)
To display the general status of the modem, go to radio view and enter the following command in radio view:
radio[x/x]>modem show status
The following is a sample output of the
MSE[db]: -99.00
Defective Blocks count: 0
Current Tx profile: 0
Current Tx QAM: 4
Current Tx rate(Kbps): 43389
Current Rx profile: 0
Current Rx QAM: 4
Current Rx rate(Kbps): 43389
radio [1/1]>modem show status
MSE[db]: -99.00
Defective Blocks count: 0
Current Tx profile: 0
Current Tx QAM: 4
Current Tx rate(Kbps): 43389
Current Rx profile: 0
Current Rx QAM: 4
Current Rx rate(Kbps): 43389
radio [1/1]>
command:
modem show status
phn-3965_006v002
Page 17-18
Configuring and Viewing Radio PMs and Statistics (CLI)