Chapter 6: Ethernet Services and Interfaces
Figure 208 Ethernet PM Port Admin Page
2.
Select the interface.
3.
Click Enable Port PM or Disable Port PM to enable or disable the gathering of Port TX PMs on the selected
interface.
4.
Click Close.
Setting the Ethernet Port TX Threshold
The TX bytes Layer 1 exceed threshold (sec) column shows, for each interval, the number of seconds the TX bytes
exceeded the specified threshold during the interval:
To view and set this threshold:
1.
In the Ethernet Port TX PM Report page, click Threshold. The Ethernet Port Tx Threshold page opens.
Figure 209: Ethernet Port Tx Threshold Page
2.
Enter a threshold, between 0 and 4294967295.
3.
Click Apply, then Close.
phn-3965_006v002
Page 6-36
Viewing Ethernet PMs and Statistics