Cambium Networks PTP 820 Series User Manual page 839

Chapter 18: Ethernet Services and Interfaces (CLI)
The following commands configure Service Point 1 in Service 37 to apply a CoS value of 5 to frames that ingress the
service point:
service[37]>sp cos-mode set spid 1 mode sp-def-cos
service[37]>sp sp-def-cos set spid 1 cos 5
The following command configures Service Point 1 in Service 37 to preserve the CoS decision made at the interface
level for frames that ingress the service point:
service[37]>sp cos-mode set spid 1 mode interface-decision
Enabling and Disabling Flooding (CLI)
The ingress service point for a frame can forward the frame within the service by means of flooding or dynamic
MAC address learning in the service.
To enable or disable forwarding by means of flooding for a service point, go to service view for the service and
enter the following command:
service[SID]>sp flooding set spid <sp-id> state <flooding state>
Table 190 Service Point Enable/Disable Flooding CLI Parameters
Parameter Input Type
sp-id Number
state Variable
The following command configures Service Point 1 in Service 37 to flood incoming frames with unknown MAC
addresses to other service points:
service[37]>sp flooding set spid 1 state allow
The following command configures Service Point 1 in Service 37 not to flood incoming frames with unknown MAC
addresses to other service points:
service[37]>sp flooding set spid 1 state disable
Configuring Service Point Egress Attributes (CLI)
A service point's egress attributes are attributes that operate upon frames ingressing via the service point. This
includes VLAN preservation and marking attributes.
This section includes:
•
Configuring VLAN and CoS Preservation (CLI)
•
Configuring Service Bundles (CLI)
Permitted Values Description
1-32 for P2P and The Service Point ID.
MP services.
1-30 for MNG
services.
Allow Determines whether incoming frames with
unknown MAC addresses are forwarded to other
disable
service points via flooding.
phn-3965_006v002
Page 18-20
Configuring Ethernet Services (CLI)