Cambium Networks PTP 820 Series User Manual page 743

Chapter 15: Configuration Guide (CLI)
The following commands display details about the LAG::
root> ethernet interfaces group lag2
eth group [lag2]>
eth group [lag2]> port static-lag show members
Static-lag members
-------------------
Eth#[1/1]
Eth#[1/2]
Eth#[1/3]]
eth group [lag2]> summary show
Group lag2 Summary: Value
Port Description:
Port Admin state: enable
Port Operational state: down
Port Edge state: non-edge-port
Member Port#(1) 1/1
Member Port#(2) 1/2
Member Port#(3) 1/3
eth group [lag2]> operational state show
Port operational state: up.
eth group [lag2]>
The following commands remove Ethernet port 2 from the LAG:
root> platform if-manager set interface-type ethernet slot 1 port 2 admin
down
root> ethernet interfaces group lag2
eth group [lag2]>
eth group [lag2]> port static-lag remove member interface eth slot 1 port
2
Configuring LACP (CLI)
To enable LACP on a LAG group, go to interface view for the LAG and enter the following command:
eth group [lagx]> lacp admin set enable
To disable LACP on a LAG group, go to interface view for the LAG and enter the following command:
eth group [lagx]> lacp admin set disable
To display whether or not LACP is enabled on a LAG group, go to interface view for the LAG and enter the following
command:
eth group [lagx]>lacp admin show
The following commands enable LACP for LAG group 1:
root> ethernet interfaces group lag1
eth group [lag1]>lacp admin set enable
eth group [lag1]>
Configuring Link Aggregation (LAG) and LACP (CLI)
phn-3965_006v002
Page 15-12