Cambium Networks PTP 820 Series User Manual page 761

Chapter 16: Unit Management (CLI)
Configuring the Remote Unit's IP Address (CLI)
You can configure the remote radio's IP address, subnet mask and default gateway in IPv4 format and/or in IPv6
format. The remote unit will receive communications whether they were sent to its IPv4 address or its IPv6
address.
Note
If you want to change the Remote IP Address to a different subnet, you must first change the
address of the Remote Default Gateway to 0.0.0.0, then set the Remote IP Address as desired, and
the Remote Default Gateway as desired.
Similarly, if you want to change the Remote IPv6 Address to a different subnet, you must first
change the address of the Remote IPv6 Default Gateway to 0:0:0:0:0:0:0:0, then set the Remote
IPv6 Address as desired, and the Remote IPv6 Default Gateway as desired.
Configuring the Remote Radio's IP Address in IPv4 format (CLI)
To configure the remote radio's default gateway, enter the following command in radio view:
radio[x/x]>remote-unit set default-gateway IP <ipv4-address>
To display the remote radio's default gateway, enter the following command in radio view:
radio[x/x]>remote-unit show default-gateway
To set the remote radio's IP Address, enter the following command in radio view:
radio[x/x]>remote-unit set ip-address <ipv4-address>
To display the remote radio's IP Address, enter the following command in radio view:
radio[x/x]>remote-unit show ip-address
To set the remote radio's subnet mask, enter the following command in radio view:
radio[x/x]>remote-unit set subnet-mask IP <subnet-mask>
To display the remote radio's subnet mask, enter the following command in radio view:
radio[x/x]>remote-unit show subnet-mask
Table 147 Remote Unit IP Address (IPv4) CLI Parameters
Parameter Input Type
ipv4-address Dotted decimal format.
subnet-mask Dotted decimal format.
Permitted Values
Any valid IPv4 address.
Any valid subnet mask.
phn-3965_006v002
Page 16-3
Configuring the Remote Unit's IP Address (CLI)
Description
Sets the default gateway or IP
address of the remote radio.
Sets the subnet mask of the
remote radio.