Chapter 5: Radio Configuration
3.
Configure the remote radio parameters. For a description of these parameters, see
Parameters.
4.
Click Apply.
Figure 159: Remote Radio Parameters Page Per Carrier – PTP 820G
You can also reset the remote radio or the entire remote unit from the Remote Radio Parameters – Edit page:
•
To reset the remote radio, click Reset remote Slot.
•
To reset the entire remote unit, click Reset Remote Unit.
.Table 45 Remote Radio Parameters
Parameter
Radio Location
Remote Radio Location
Local Remote Channel
Operational Status
Remote Receiver Signal
Level
Definition
Identifies the radio interface (Slot 1, port 1 or Slot 1, port 2).
Read-only. Identifies the location of the remote radio.
Read-only. The operational status of the active (in a protection
configuration) remote channel.
Read-only. The Rx level of the remote radio, in dBm.
phn-3965_006v002
Page 5-11
Configuring the Remote Radio Parameters
Table 45 Remote Radio