Cambium Networks PTP 820 Series User Manual page 447

Chapter 7: Quality of Service (QoS)
Figure 245 Logical Interfaces – Egress Service Bundle Shaper Configuration – Add Page
Note
In this release, only one service bundle (Service Bundle ID 1) is supported.
5. In the Profile ID field, select from a list of configured service bundle shaper profiles. See
Bundle Shaper Profiles.
6. In the Shaper Admin field, select Enable to enable egress service bundle shaping, or Disable to disable
egress service bundle shaping.
7. Click Apply, then Close.
To assign a different service bundle shaper profile:
1. Select Ethernet > Interfaces > Logical Interfaces. The Logical Interfaces page opens
2. Select an interface in the Ethernet Logical Port Configuration table and click Shaper. The Logical Interfaces –
Shaper page opens, with the Egress Queue Shaper Configuration table open by default
3. Select Egress Service Bundle Shaper. The Egress Service Bundle Shaper Configuration table appears
244). All service bundle shaper profiles defined in the system are listed in the table.
4. Select the row you want to edit and click Edit. The Egress Service Bundle Shaper Configuration – Edit page
opens. This page is similar to the Egress Service Bundle Shaper Configuration – Add page
5. To assign a different egress queue shaper profile, select the profile in the Profile ID field.
6. To enable or disable egress service bundle shaping, select Enable or Disable.
7. Click Apply, then Close.
phn-3965_006v002
Page 7-36
Configuring Egress Shaping
Configuring Service
(Figure 214).
(Figure 242).
(Figure
(Figure 245).