Chapter 3: Configuration Guide
Figure 49 1+0 Quick Configuration Wizard (PTP 820G) – Page 1
Figure 50 1+0 Quick Configuration Wizard (PTP 820F) – Page 1
2
In the Ethernet Interface field, select an Ethernet interface or a LAG for the link. Alternatively, click the
interface in the graphical representation of the unit. The selected interface is surrounded by a blue square, as
shown in
Figure 49
and Figure 50
Note
To create a LAG, click Create LAG. The Create LAG Group page opens. For instructions on creating
LAG groups, see
3
In the Radio Interface field, select a radio interface for the link. Alternatively, click the interface in the
graphical representation of the unit. The selected interface is surrounded by a green circle, as shown in
Figure 49
and Figure 50
4
In the Pipe Type field, select the Attached Interface type for the service that will connect the radio and
Ethernet interfaces. Options are:
Configuring Link Aggregation (LAG) and LACP
phn-3965_006v002
Page 3-6
Configuring a Link Using the Quick Configuration Wizard