Cambium Networks PTP 820 Series User Manual page 445

Chapter 7: Quality of Service (QoS)
6. In the Shaper Admin field, select Enable to enable egress queue shaping for the selected queue, or Disable
to disable egress queue shaping for the selected queue.
7. Click Apply, then Close.
To assign a different queue shaper profile to a queue:
1. Select Ethernet > Interfaces > Logical Interfaces. The Logical Interfaces page opens
2. Select an interface in the Ethernet Logical Port Configuration table and click Shaper. The Logical Interfaces –
Shaper page opens, with the Egress Queue Shaper Configuration table open by default
3. Select an interface in the Ethernet Logical Port Configuration table and click Shaper. The Logical Interfaces –
Shaper page opens, with the Egress Queue Shaper Configuration table open by default
4. Select the row you want to edit and click Edit. The Egress Queue Shaper Configuration – Edit page opens. This
page is similar to the Egress Queue Shaper Configuration – Add page
5. To assign a different egress queue shaper profile, select the profile in the Profile ID field.
6. To enable or disable egress queue shaping for the selected queue, select Enable to enable egress queue
shaping for the queue, or Disable to disable egress queue shaping for the queue.
7. Click Apply, then Close.
(Figure
phn-3965_006v002
Page 7-34
Configuring Egress Shaping
(Figure 214).
(Figure 242).
(Figure 242).
243).