Cambium Networks PTP 820 Series User Manual page 850

Chapter 18: Ethernet Services and Interfaces (CLI)
To perform a global flush of the MAC address forwarding table, enter the following command:
root> ethernet service mac-learning-table set global-flush
Enabling MAC Address Learning on a Service Point (CLI)
You can enable or disable MAC address learning for specific service points. By default, MAC learning is enabled.
To enable or disable MAC address learning for a service point, go to service view for the service and enter the
following command:
service[SID]>sp learning-state set spid <sp-id> learning <learning>
Table 200 Enabling MAC Address Learning CLI Parameters
Parameter Input Type
sp-id Number
learning Variable
The following command enables MAC address learning for Service Point 1 on Service 37:
service[37]>sp learning-state set spid 1 learning enable
The following command disables MAC address learning for Service Point 1 on Service 37:
service[37]>sp learning-state set spid 1 learning disable
Permitted Values Description
1-32 for P2P and MP The Service point ID.
services.
1-30 for MNG
services.
enable Select
disable disable MAC address learning for frames
that ingress via the service point. When
enabled, the service point learns the
source MAC addresses of incoming frames
and adds them to the MAC address
forwarding table.
phn-3965_006v002
Page 18-31
Configuring Ethernet Services (CLI)
or to enable or
enable disable