5) Slide lock plate (3) in the direction of C, until it gets
over the claw (4) of cable end holder.
3
4
C
3
A
Back Up Light Switch Removal and Installation
Removal
1) Remove battery and tray with ECM.
2) Disconnect back up light switch coupler (1).
3) Remove back up light switch.
2. Gear shift and select shaft assembly
1
B
5,
"A"
1
2
I4RS0A520005-01
S6RW0C5206007
2
1
I5RW0A520009-01
Manual Transmission/Transaxle:
Installation
1) Apply oil to new O-ring (1) and tighten back up light
switch (2) to specified torque.
Tightening torque
Back up light switch (a): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
1
2) Connect back up light switch coupler.
3) Install battery and tray with ECM.
Back Up Light Switch Inspection
Check backup light switch for function using ohmmeter.
Switch ON (Push): Continuity
Switch OFF (Release): No continuity
5B-11
2, (a)
I3RH0A520006-01
S6RW0C5206008
I5RW0A520050-01