Back Up Light Switch Removal and Installation
Removal
WARNING
!
Refrain from work while exhaust No.2 pipe is
hot.
NOTE
When replacing switch, use care not to let
dust enter transmission through switch hole.
1) Hoist vehicle and disconnect connector from back up
light switch.
2) Remove back up light switch (1) from transmission
rear case.
1
Installation
Reverse removal procedure for installation noting the
following.
• Apply oil to new O-ring (1) and then install back up
light switch (2) to transmission rear case.
Tightening torque
Back up light switch (a): 19 N·m (1.9 kgf-m, 14.0
lb-ft)
1
• Check back up light for proper function with ignition
switch turned ON and reverse position.
Manual Transmission/Transaxle: For Petrol Engine Model 5B-12
Back Up Light Switch Inspection
S6JB0A5216009
Check back up light switch for function using ohmmeter.
If resistance is not as specified below, replace back up
light switch.
Back up light switch specification
Switch ON (Push): Continuity
Switch OFF (Release): No continuity
Gear Shift Control Lever Rear Case Assembly
Removal and Installation
4WD model
Removal
1) Dismount transmission assembly from vehicle
I5JB0A520005-01
2) Remove gear shift control lever rear case assembly
2, (a)
I5JB0A520004-01
referring to "Manual Transmission Assembly
Dismounting and Remounting: For Petrol Engine
Model".
(1) with plate (2) from transfer case.
1
S6JB0A5216010
I5JB0A520006-01
S6JB0A5216011
2
I5JB0A520007-03