Passive-Interface - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

passive-interface

Disable (suppress) sending routing updates on an interface.

passive—interface interface

To enable sending routing updates on an interface, use the no passive-

interface interface command.

Enabled, that is sending of routing updates are enabled by default.

ROUTER OSPF for OSPFv2

ROUTER OSPFv3 for OSPFv3

By default, no interfaces are passive. Routing updates are sent to all interfaces on

which the routing protocol is enabled.

If you disable the sending of routing updates on an interface, the particular address

prefix continues to be advertised to other interfaces, and updates from other

routers on that interface continue to be received and processed.

OSPFv3 for IPv6 routing information is not sent or received through the specified

router interface. The specified interface address appears as a stub network in the

OSPFv3 for IPv6 domain.

Open Shortest Path First (OSPFv2 and OSPFv3)

Enter the following keywords and slot/port or number

information:

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a port channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the Z9500.

Introduced support for OSPFv3 on the S4810 and Z9000.

Introduced on the S4820T.

Added support for the C-Series.

Introduced on the E-Series.