Ipv6 Pim Dr-Priority - Dell Z9500 Command Reference Manual

priority
Defaults Refer to Parameters.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
8.3.19.0
8.3.12.0
7.4.1.0

ipv6 pim dr-priority

Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority
command.
Parameters
priority-value
Defaults 1
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
8.3.19.0
1406
(OPTIONAL) Enter the priority value for Bootstrap election
process. The range is from 0 to 255. The default is 0.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S6000.
Enter a number. Preference is given to larger/higher number.
The range is from 0 to 4294967294. The default is 1.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4820T.
PIM-Sparse Mode (PIM-SM)