Dell Z9500 Command Reference Manual page 1398

Version
8.3.19.0
8.3.12.0
8.4.1.1
Usage The following describes the show ip pim snooping tib commands shown in
Information the following example.
Field
(S, G)
uptime
expires
RP
flags
Incoming
interface
RPF neighbor
Outgoing
interface list:
Example
Dell#show ip pim snooping tib
PIM Multicast Snooping Table
Flags: J/P - (*,G) Join/Prune, j/p - (S,G) Join/Prune
Timers: Uptime/Expires
* : Inherited port
1398
Description
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Description
Displays the entry in the PIM multicast snooping database.
Displays the amount of time the entry has been in the PIM
multicast route table.
Displays the amount of time until the entry expires and is
removed from the database.
Displays the IP address of the RP/source for this entry.
List the flags to define the entries:
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = Dell Networking OS is registering this entry for a
multicast source
• T = packets were received via Shortest Tree Path
• J = first packet from the last hop router is received and
the entry is ready to switch to SPT
• K=acknowledge pending state
Displays the reverse path forwarding (RPF) interface towards
the RP/ source.
Displays the next hop from this interface towards the RP/
source.
Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group
• statically configured member of the Group
• received a (*,G) Join message
SGR-P - (S,G,R) Prune
PIM-Sparse Mode (PIM-SM)