Show Interfaces Configured - Dell Z9500 Command Reference Manual

show inventory (S-Series and Z-Series)
types, components (including media), Dell Networking OS version including
hardware identification numbers, and configured protocols.
show ip interface
show range
command.

show interfaces configured

Display any interface with a non-default configuration.
Z9500
Syntax
show interfaces configured
Command
•
Modes
•
Command
Version
History
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.4.1.0
Example
Dell# show interfaces configured
TenGigabitEthernet 2/0 is down, line protocol is down
Hardware is DellForce10Eth, address is 74:86:7a:ff:6f:18
Pluggable media present, Media type is unknown
Interface index is 151060994
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 01:47:42
Queueing strategy: fifo
Input Statistics:
Interfaces
– displays Layer 3 information about the interfaces.
– displays all interfaces configured using the interface range
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Changed the organization of the display output.
Current address is 74:86:7a:ff:6f:18
Wavelength is 0.00nm
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
– displays the S-Series and Z-Series switch
873