Ip Split-Horizon - Dell Z9500 Command Reference Manual

Version
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Usage To enable the interface to send both version of RIP packets, use the ip rip send
Information version 1 2 command.
Related
ip rip receive version
Commands
version

ip split-horizon

Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme
prevents any routes learned over a specific interface to be sent back out that interface.
Z9500
Syntax
ip split-horizon
To disable split-horizon, use the no ip split-horizon command.
Defaults Enabled
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
1544
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the RIP version for the interface to receive traffic.
— sets the RIP version for the switch software.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Routing Information Protocol (RIP)