Revision - Dell Z9500 Command Reference Manual

Usage
MSTP is not enabled when you enter MULTIPLE SPANNING TREE mode. To enable
Information
MSTP globally on the switch, enter the no disable command while in MULTIPLE
SPANNING TREE mode.
For more information about the multiple spanning tree protocol, refer to the Dell
Networking OS Configuration Guide.
Example
Dell(conf)#protocol spanning-tree mstp
Dell(config-mstp)#no disable
Related disable
Commands

revision

The revision number for the multiple spanning tree configuration.
Z9500
Syntax
revision range
To return to the default values, use the no revision command.
Parameters
range
Defaults 0
Command MULTIPLE SPANNING TREE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
1242
— disables multiple spanning tree.
Enter the revision number for the MST configuration. The
range is from 0 to 65535. The default is 0.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Multiple Spanning Tree Protocol (MSTP)