Tunnel Hop-Limit - Dell Z9500 Command Reference Manual

Version
9.5(0.1)
9.3(0.0)
Usage
This command is only valid for tunnel interfaces with an IPv6 outer header.
Information

tunnel hop-limit

Configure the method to set the IPv4 time-to-live or the IPv6 hop limit value in the outer tunnel header.
Syntax
tunnel hop-limit value
To restore the default tunnel hop-limit, use the no tunnel hop-limit
command.
Parameters
value
Defaults 64 (Time-to-live for IPv4 outer tunnel header or hop limit for IPv6 outer tunnel
header)
Command INTERFACE TUNNEL (conf-if-tu)
Modes
Command
Version
History
9.7(0.0)
9.5(0.1)
9.3(0.0)
Usage
A value of 0 copies the inner packet hop limit (ipv6) or time-to-live (ipv4) in the
Information
encapsulated packet to the tunnel header hop limit (ipv6) or time-to-live (ipv4)
value.
1808
Description
Introduced on the Z9500.
Introduced on the S6000, S4810, S4820T, Z9000.
Enter the hop limit (ipv6) or time-to-live (ipv4) value to
include in the tunnel header. The range is from 0 to 255. The
default is 64.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000, S4810, S4820T, Z9000.
Tunneling