Interface Port-Channel - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
Related
port-channel failover-group
Commands
mode to configure a LAG failover group.
show interfaces port-channel
groups.

interface port-channel

Create a Port Channel interface, which is a link aggregation group (LAG) containing eight physical
interfaces on the S-Series.
Z9500
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-
number command.
Parameters
channel-
number
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
894
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series, E-Series, and S-Series.
— accesses PORT-CHANNEL FAILOVER-GROUP
— displays information on configured Port Channel
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Interfaces