Ip Name-Server - Dell Z9500 Command Reference Manual

Layer 2 Overhead
Tagged Packet
with VLAN-Stack
Header
Related mtu
Commands

ip name-server

Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order
of their use.
Z9500
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
Parameters
ipv4-address
ipv4-address2...
ipv4-address6
Defaults No name servers are configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
952
Difference between Link MTU and IP MTU
26 bytes
— sets the link MTU for an Ethernet interface.
Enter the IPv4 address, in dotted decimal format, of the
name server to be used.
(OPTIONAL) Enter up five more IPv4 addresses, in dotted
decimal format, of name servers to be used. Separate the
addresses with a space.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
IPv4 Routing