Dell Z9500 Command Reference Manual page 974

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For the Management interface on the stack-unit, enter

the keyword ManagementEthernet then the slot/port

information. The slot range is from 0 to 1. The port range

For a port channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a Null interface, enter the keyword null then the Null

interface number.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

For a stack-unit interface, enter the keyword stack-

unit then the stack unit number.

For a tunnel interface, enter the keyword tunnel then

the tunnel interface number. The range is from 1 to

(OPTIONAL) Enter the keyword brief to view a brief

summary of the interfaces and whether an IP address is

(OPTIONAL) Enter the keyword configured to display the

physical interfaces with non-default configurations only.

EXEC Privilege

Introduced on the S6000-ON.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Supported on the E-Series ExaScale E600i.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

IPv4 Routing