Dell Z9500 Command Reference Manual page 983

Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage The following describes the show ip route summary shown in the following
Information
example.
Column Heading
Route Source
Active Routes
Non-active
Routes
ospf 100
Total 1388
active...
Example
Dell>show ip route summary
Route Source
connected
static
ospf 100
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total
Total 1388 active route(s) using 222440 bytes
IPv4 Routing
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Identifies how the route is configured in the system.
Identifies the best route if a route is learned from two
protocol sources.
Identifies the back-up routes when a route is learned by two
different protocols. If the best route or active route goes
down, the non-active route becomes the best route.
If routing protocols (OSPF, RIP) are configured and routes
are advertised, then information on those routes is
displayed.
Displays the number of active and non-active routes and
the memory usage of those routes. If there are no routes
configured in the system, this line does not appear.
Active Routes
17
3
1368
1388
Non-active Routes
0
0
2
2
983