Show Ipv6 Neighbors - Dell Z9500 Command Reference Manual

Field
Reports
Leaves
MLDv1 queries
MLDv2 queries
Malformed
Packets
Example
MLD Host Traffic Counters
Elapsed time since counters cleared: 0028:33:52
Valid MLD Packets
Reports
Leaves
MLDv2 Queries
MLDv1 Queries
Errors:
Malformed Packets: 4510

show ipv6 neighbors

Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the control processor (CP).
Z9500
Syntax
show ipv6 neighbors [vrf vrf-name] [cpu rp [ipv6–address]
[ipv6-address| interface interface]
Parameters
vrf vrf-name
cpu rp
ipv6–address
ipv6-address
1040
Description
The total number of reports (queries and unsolicited reports
generated from joins or leaves) that have been received or
sent.
The number of Multicast leaves that have been sent.
The number of MLDv1 queries that have been received.
The number of MLDv2 queries that have been received.
The number of MLDv1 and MLDv2 packets that do not
match the requirement for a valid MLD packet.
Received Sent
97962 18036
79962 18034
---- 0
18000 ----
0 ----
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to display the neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors
corresponding to the default VRF are displayed.
Enter the keywords cpu rp to display information about
IPv6 neighbors learned only on the Route Processor.
Enter the IPv6 address of a neighbor to display information
about the specified device.
Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
IPv6 Basics