Usage
This command allows you to monitor adjacency state changes, which are useful
Information
when you monitor large networks. Messages are logged in the system's error
message facility.
lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
Z9500
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l |
level-2] interval seconds [initial_wait_interval seconds
[second_wait_interval seconds]] command.
Parameters
level-l
level-2
interval
seconds
initial_wait_inte
rval seconds
second_wait_i
nterval seconds
Defaults
Refer to Parameters.
Command
ROUTER ISIS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
1096
(OPTIONAL) Enter the keywords level-1 to apply the
configuration to generation of Level-1 LSPs.
(OPTIONAL) Enter the keywords level-2 to apply the
configuration to generation of Level-2 LSPs.
Enter the maximum number of seconds between LSP
generations. The range is from 0 to 120 seconds. The default
is 5 seconds.
(OPTIONAL) Enter the initial wait time, in seconds, before
running the first LSP generation. The range is from 0 to 120
seconds. The default is 1 second.
(OPTIONAL) Enter the wait interval, in seconds, between the
first and second LSP generation. The range is from 0 to 120
seconds. The default is 5 seconds.
Description
Introduced on the Z9500.
Intermediate System to Intermediate System (IS-IS)