Dell Z9500 Command Reference Manual page 1037

managementet
hernet slot/
port
loopback
port-channel
tengigabitether
net
fortyGigE
tunnel tunnel-
id
vlan
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.2(1.0)
9.2.(0.0)
9.0.0.0
8.3.19.0
8.3.7.0
8.5.1.0
8.4.2.1
8.2.1.0
7.8.1.0
7.4.1.0
Usage The Management port is enabled by default (no shutdown). If necessary, use the
Information
ipv6 address command to assign an IPv6 address to the Management port.
Example
Dell# show ipv6 interface linecard 0
TenGigabitEthernet 0/2 is down, line protocol is down
IPv6 Basics
(OPTIONAL) View information on an IPv6 Management port.
Enter the slot number (0-1) and port number zero (0).
(OPTIONAL) View information for IPv6 Loopback interfaces.
(OPTIONAL) View information for IPv6 port channels.
(OPTIONAL) View information for an IPv6 tengigabitethernet
interface.
(OPTIONAL) View information for an IPv6
fortygigabitethernet interface.
(OPTIONAL) View information for a tunnel interface.
(OPTIONAL) View information for IPv6 VLANs.
EXEC
EXEC Privilege
Description
Added support for IPv6 recursive DNS addresses.
Introduced on the Z9500.
Added support for tunnel interface.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S-Series.
Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
1037