Timers Basic - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.6.1.0
Example
show running-config rip
!
router rip

timers basic

Manipulate the RIP timers for routing updates, invalid, holddown times, and flush time.
Z9500
Syntax
timers basic update invalid holddown flush
To return to the default settings, use the no timers basic command.
Parameters
update
invalid
1558
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
distribute-list Test1 in
distribute-list Test21 out
network 10.0.0.0
passive-interface TenGigabitEthernet 2/0
neighbor 20.20.20.20
redistribute ospf 999
version 2
Enter the number of seconds to specify the rate at which RIP
routing updates are sent. The range is from zero (0) to
4294967295. The default is 30 seconds.
Enter the number of seconds to specify the time interval
before routing updates are declared invalid or expired. The
invalid value should be at least three times the update timer
value. The range is from zero (0) to 4294967295. The default
is 180 seconds.
Routing Information Protocol (RIP)