Dell Z9500 Command Reference Manual page 959

tcp-udp enable
ingress-port
enable
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.10.0
8.3.7.0
7.6.1.0
7.5.1.0
Usage By default, the system distributes incoming traffic based on a hash algorithm using
Information the following criteria:
•
•
•
•
IPv4 Routing
returns a 3-bit index indicating which port the packet
should be forwarded.
• source-mac — Uses the source MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index
indicating which port the packet should be forwarded.
Enter the keywords to distribute traffic based on the
following:
• enable — Takes the TCP/UDP source and destination
ports into consideration when doing hash computations.
This option is enabled by default.
Enter the keywords to distribute traffic based on the
following:
• enable — Takes the source port into consideration when
doing hash computations. This option is disabled by
default.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added the ingress-port parameter for the S4810.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
IP source address
IP destination address
TCP/UDP source port
TCP/UDP destination port
959