Dell Z9500 Command Reference Manual page 1142

Hide thumbs Also See for Z9500:

Table of Contents

vlan vlan-id

station-move-

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

This command and its options are supported on physical interfaces, static LAGs,

LACP LAGs, and VLANs.

If you do not specify the vlan option, the MAC address counters are not VLAN-

based. That is, the sum of the addresses learned on all VLANs (not having any

learning limit configuration) is counted against the MAC learning limit.

MAC Learning Limit violation logs and actions are not available on a per-VLAN

With the keyword no-station-move option, MAC addresses learned through this

feature on the selected interface persist on a per-VLAN basis, even if received on

E-Series only: Enter the keyword then the VLAN ID. The

range is from 1 to 4094.

(OPTIONAL) Enter the keyword dynamic to allow aging of

MACs even though a learning limit is configured.

(OPTIONAL) Enter the keywords station-move to allow a

station move on learned MAC addresses.

On S-Series, the default behavior is dynamic.

NOTE: "Static" means manually entered addresses, which do not age.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Deprecated the no-station-move command (replaced by

the mac-learning-limit mac-address-sticky

Introduced on the S4810.

Added the vlan option on the E-Series.

Introduced on the S-Series.

Introduced on the C-Series. Added the station-move

Added support for MAC Learning-Limit on the LAG.